-
May 17th, 2006, 02:34 AM
#161
Inactive Member
Opps, I just remembered that the fitting on the thermostat end is a reverse or male. I think you will be needing a new ferrule and nut for that end of the tubing. When you get into your stove and verify my memory, let me know. I can send you the needed 5/32 ferrule and nut.
-
May 17th, 2006, 10:30 PM
#162
Inactive Member
Mr. Stoveman,
Thank you for the offer. I looked at my pilot light tubing and it appears to be the same on both ends. When I start to put it back together, after I install the safety valve, I shall let you know.
Any ideas on what size plug I need for the thermostat? 5/32?
Gasseous
-
May 19th, 2006, 11:10 PM
#163
Inactive Member
Mark,
I ordered the parts for the safety today. I was looking at your list of required parts and noticed that you used 3/8" aluminum tubing for the inlet/outlet gas source. The valve assembly says it is a 1/2".... Is this correct?
Just curious.....
Gasseous
-
May 20th, 2006, 12:48 AM
#164
Inactive Member
Look at Page 2, Table 2, Item: [3/8 Comp x 1/2 MPT], that is the fitting that connects the 1/2 threaded safety valve to the 3/8" compression fittings and 3/8" tubing. You can see a good photo of these fittings in place on page 9.
Remember the document is for amusement only. If you blow yourself up, it's your fault not mine.
-
May 20th, 2006, 01:30 AM
#165
Inactive Member
Mark,
I noticed that after I had posted.... Thanks for clarifying it for me... LOL!! I shall let you know how it goes.... probably sometime next week before I receive the parts....
Gasseous
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks