-
May 4th, 2005, 02:48 AM
#1
Inactive Member
Would you recommend installing the entire jrsc, including alternator and all belts before dropping the motor back into car? Would I experience any issues with clearance?
I will be running the mvm stepper pulley [img]smile.gif[/img] but I am concerned about heatsoak. Is anybody running mvm pulley without a water injection or lht? What are you thoughts.
-
May 4th, 2005, 03:11 PM
#2
Senior Hostboard Member
If the engine is out of the car... install the JRSC BEFORE you put the engine back in !!! It is much easier that way and there are no additional clearance issues.
MANY MANY people run 8-10 psi without water injection or the LHT intercooler... we did it far before these products were available. With proper tuning, you will be just fine.
-
May 4th, 2005, 09:34 PM
#3
Inactive Member
I ran my 11psi JRSC, MVM pulley & no WI w/out any problems...I had Hondata s200...like Jim said, proper tuning is the key...
-
May 5th, 2005, 05:35 PM
#4
Inactive Member
i ran 9 psi with no water injection and just the JR band aids. two cylinders now have 20% leakage and compression is now at 135 [img]frown.gif[/img] i suspect #3 & 4 ringlands are gone.
actually, on the dyno, the readings were giving us 11.5 psi, not 9.
<font color="#a62a2a" size="1">[ May 05, 2005 02:39 PM: Message edited by: spidermancivic ]</font>
-
May 5th, 2005, 07:59 PM
#5
Inactive Member
and I am assuming you were properly tuned with hondata?
-
May 5th, 2005, 09:41 PM
#6
Inactive Member
I ran 10-11 PSI both with the FMU/stock injectors and with a Hondata S200/RC440 injectors.
With the FMU, MAP controller, BTC, and Walbro 255 fuel pump, I found that it ran crappily for a couple of days and then broke all the rings and ring lands on my pistons.
After a rebuild, I opted for the Hondata S200 with RC440 injectors and it worked very well.
-
March 11th, 2023, 05:46 PM
#7
Junior Hostboard Member
Re: question about sc installation &running mvm pulley with
Hand embroidery is the most traditional form of embroidery, and is still widely practiced today. Hand embroidery typically involves a needle and thread, but other materials such as beads, sequins, and pearls can also be used. Hand embroidery is time-consuming and can be quite intricate, but the results can be beautiful. Embroidery
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks