-
December 20th, 2003, 01:17 AM
#1
Inactive Member
Would the specs for the 416A woofer be the same as those given on the website for the
416-8B?
-
December 20th, 2003, 04:51 PM
#2
Senior Hostboard Member
Don't know about the 416A, but while the -8A and -8C are very close, the -8B is completely different, so there's no telling what the 416A's is. If you can't get the specs, I'm guessing the -8B's specs is a worst case scenario WRT Vb/Fb, so you could design around them. If it winds up being too rolled off, then you can use scrap to decrease Vb and use a shorter vent to tune it higher to maintain efficiency, or use series resistance to increase the apparent Qts to flatten it out, which will make it perform ~like an -8B in the cab's controlling BW.
GM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
This forum has been viewed: 21311928 times.
Bookmarks