-
I will be installing the J&S Safeguard on my OBD2 Integra. If you have done this, would you be so kind as to tell me which wires at the ECU are for the Ignition, and the TPS sensor. As I remember those are the ones I need. If I've left anything out, let me know. Single Monitor.
I helped Mr Rogers install his, but he did the wiring, so I'm not sure which ones I need.
Yes I really need a Helms Manual, but I don't have one.
I'll be talking photo's of the install, and will post a complete install for OBD2 on my site when I'm done.
Thanks all!
------------------
Lundgren
Lundgren's Integra Site
My AllAdvantage Page
The Groupbuy Center
-
Well I guess I could tell you the right ones since I didn't let you sneek a peek. First of all you will need to tap the power wire which is Yel/Blk, it is in the 32p connector (it says on the top of the plug) and should be in the upper right hand corner, there is another Yel/Blk power wire directly below that one that can be used also. The Ignition wire is in the same connector and is Yel/Grn and is right in the middle of the connector. The TPS wire is in the 16p connector (this is the smallest of the three connectors) and is Red/Blk and is in the upper left-hand corner. Good luck and if you need any others let me know.
-
Are all the 12V power wires yellow/black?
Remember when I said I didn't have the Purge solenoid valve (so no 12v power wire to tap into for the JR relay). Well, I just tapped into another yellow/black wire going into the distributor together with the wire from the MSD6BTM. Cars starts but I might decide to relocate all the wires to the ECU to tidy up the engine compartment.
-
How about the wires for the air/fuel monitor also? Thanks.
Jon
-
Go to lundgren's page...under modifications he has notes on installing a A/F gauge specific to OBD2.
-
The J&S Instructions say red/grn is the ignition wire. Discrepancy?
-
Sure enough. Mr Rogers was right on. J&S installed. The bad part though, is that it is snowing, and there is no way I can get the car out to test it. We'll hopefully another day.
This will give me some time to write up the install.
------------------
Lundgren
Lundgren's Integra Site
My AllAdvantage Page
The Groupbuy Center
-
I thought on that page on the hybrid board that you list on the groupbuy centre had some info on the diffs between OBD I and II and it said there was some diff but i do not remember which wires were different.
Kyle
