i put a zc into a 4wheel drive civic and it ran for a little while and then gave a little gas now it wont run. i have spark, fuel, good timing, and air. no codes are showing. what am i missing.
------------------
Printable View
i put a zc into a 4wheel drive civic and it ran for a little while and then gave a little gas now it wont run. i have spark, fuel, good timing, and air. no codes are showing. what am i missing.
------------------
be more specific... what is it doing? or the lack of? will it start up? anything in particular that seems strange
------------------
89 CRX Si
and a 89 CRX Dx(winter beater)
aight, since it's running, does it rev properly? or does it fight to climb in the rpm? i'm thinking it could possiblly be the fuel filter, or maybe like a clogged injector, so its still getting gas but not enough. did ya notice anything else about it that seems out of the ordinary?
------------------
89 CRX Si
and a 89 CRX Dx(winter beater)
it will start and run rough at about 250 rpm but if you shut it off it will not start again for awhile. i put new plugs, wires, cap and rotor.
------------------
i worked on it again last night,put a new fuel filter in, since the car has 200k on it. and replaced the injectors. the fuel purge valve makes a clicking sound so i am replacing that too. the timing just does not look right. shouldnt the marks on the cam gears all line up? if you give it any gas it will stall. idles at 200rpm, you know what that sounds like.
------------------
ok,it could be the MAP Sensor,Distributor or the Catalytic Converter.That wagon had before a d16a6??? The distributor from that ZC it`s the right one??? Are you sure that catalytic is not plug-out??? What about the fuel pump??? Give more details...
------------------
i think i am getting fuel pressure, the wagon had the d16 in it before and ran fine except for bad rings. if the map sensor was bad it would throw a code, right? i did not even think to check the cat might be pluged, i will check that. any other ideas?
------------------
maybe the idle screw is too far out? that was my problem. worth a shot.
------------------
-Ben L.
1989 Civic Si
1990 300ZX TT Stage III
i put the stock tb from the d16a6 on it so the settings should be fine, but i will double check it. any other tips?
------------------