Which Blower do I have??

Picked up this supercharger off a guy, who said it was for a z6.....I plan on putting it on my 94 del sol Si.....will it work? Anything else I need? Also what size charger is it?? Thanks
http://www.geocities.com/edwardeatsrice/JRSC003.jpg

it's an m45, and yep it's for a z6(most likely, hard to say EXACTLY just from the pic tho). Definetely a dseries charger tho

check out that pulley on the charger though, it looks kinda small, might give you alot of boost.
what diameter is it?

<font color="#a62a2a" size="1">[ March 31, 2005 03:02 PM: Message edited by: Tad3d ]</font>

ok, now someone told me they made a bigger supercharger for the d-series, and I got the smaller (m45) one. I don't know the diamater of the pulley though, I haven't gotten it yet. The UPS man should be bringing in here in a matter or minutes [img]smile.gif[/img]

when it gets there look at the pulley it will have a number stamped on it.

I didn't see a # stamped on it....where would it be stamped at???

But I did measure it, and it was right around 3.25 inches across, if that helps at all

It's kind of hard to see but should be on the front of the pulley. Stock is 3.8, so I beleive you have an upgrade if that's how the numbers correspond.

that's an m45 charger man.
maybe they used an m62 on some wierd sohc.. like a dohc zc or something, i dunnoo..

but i've never heard of a sohc not using the m45(unless it was crazy custom or something)

also the newer kits used a black idle pulley bracket, older used the silver one u have.
but the really old ones said sebring in big letters
on the intake manifold, so it's not that old.

check those idler pullies, see if they need replacing.

also 3.25" is a very small blower pulley!
i have a 3.4" on mine and it makes alittle over 9psi. stock crank.
I was told anythiing smaller may have belt slippage problems.. so while youhave the charger out, think about how much boost you want to make, and think about maybe getting a bigger pulley.

I like my 3.4 alot btw.

The intake manifold looks like a DOHC ZC manifold... are you sure it is for a "D" series ???