-
Well I had my second kill today. New 2000 shiny silver vette. We got side by side at 80 MPH. I fourth gear I put around 6 car lengths on him to 120 MPH. Jim helped me tune in the fuel before I got back to work. Help out tremendously. Going to the Dyno Saturday to get the PMS tuned in by a pro with a wide band O2 sensor. She ran hot a little bit, replaced the raditor cap and it hasn't done it since, and also got a new 170 degree thermostat just in case the cap is not the fix.
But I am finally back on the road and ready for some more kills! http://www.hostboard.com/ubb/biggrin.gif
------------------
Smoking Vette's left and right, even if they put up a fight......
-
did you ever share what your total package consisted of? or did I miss it?
-
He's got a BLACKBIRD... what else does he need ???
Good job Will. I am so proud of what we have accomplished with this project.
It was nice to see that old smile of yours back on your face.
ENJOY !!!
------------------
'93 Civic Si H/B with B18C1, JRSC @ 8psi
Best 1320: 12.68 at 110 mph
-
Whatcha want to know sjoback?? anything specific??
------------------
Smoking Vette's left and right, even if they put up a fight......
-
Excellent!!
Keep us dreamers posted on how the dyno runs go and timeslips if you get it to the track for sure.
Also Will, if I'm not askin too much. Once you hit the Dyno maybe you could share some PMS settings with so I can see how a professional sets it up since my luck has once again stopped me from getting on one myself. For now.
Good luck gentelmen.
-
jeezus man I know its a blackbird. oh well.
-
I remember pictures and as much pertanent info as we needed in some pretty old posts. Search for them in the old stuff cause I know it's there. Good luck guys, and make sure we get to see the dyno plots.
------------------
98 GS-scR w/ 8psi JRSC, Walbro HO fuel pump, AEM cai, DC 4-2-1 one peice header, Thermal Exhaust, Skunk Works cam gears, J&S safeguard, RC 310's, Cartech FMU, Vortech regulator, H&R sports and KYB AGX's, and of course to slow down, KVR X-drill F&R rotors and Carbon Kevlar pads and V1 to signal the slowing down and soon to go on the "Juice".
-
Will do!!
Some specifics:
84mm pistons, titanium rods (half stock weight, knife-edged crank, fully balanced with clutch assembly installed, running a 12 psi pulley seeing 10 max. 8AN fuel line, 6AN return,350cc injectors, JW performance Axles, Type-R exhaust cam, Fiereas Valves, Jun dual valve springs, Titanium retainers, 5 angle valve job, Benson special bowl blending for SC motors..... and it goes on http://www.hostboard.com/ubb/smile.gif
------------------
Smoking Vette's left and right, even if they put up a fight......
-
is this with a stock m62 jackson blower? or is there anything in that department?
-
Yeah, Will, how about some specifics? Or are you going to be another TOO?????? :-D
