-
October 18th, 2003, 05:55 PM
#1
HB Forum Owner
Hi,
Your best bet would be to contact Mike at Vitavox Spares. His email address is at the top of this link:
Spares
Please let us know how you get on.
Best regards,
Peter.
-
October 19th, 2003, 03:48 AM
#2
Inactive Member
I am looking for S2 diaphragm, If any one know where to get it, please email me! Thanks!!!!!
-
October 20th, 2003, 10:40 AM
#3
Inactive Member
I bought an S2 diaphragm from Mike Harvey 2 weeks ago. It came very quickly and included comprehensive instructions. It is an original Vitavox manufactured part. When you have fitted the diaphragm, before you replace the back cover you should connect a signal generator and sweep the low frequency output of the driver listening for distortion. The 6 clamping screws need to be tightened in a particular way to remove all the distortion. It is a question of trial and error. You will be able to hear clearly when the output is clean. To protect the driver do this work with a horn attached and feed the input signal via a 25 uF capacitor. As Peter says, let us know how you get on. If you actually can work out a surefire method for setting up the diaphragm then we'd like to hear it!
-
October 21st, 2003, 02:16 PM
#4
Inactive Member
Hi,
Thanks you guys, thanks a lot!
Jeff
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks