Results 1 to 2 of 2

Thread: Yourself vs. Pro

  1. November 13th, 2001, 01:55 PM #1
    Dallas_Fl
    Dallas_Fl is offline
    Inactive Member Dallas_Fl's Avatar
    Join Date
    November 12th, 2001
    Posts
    57
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    can you put a B16A engine in yourself or is it better to have it put it in by a pro.

    ------------------
  2. November 13th, 2001, 01:57 PM #2
    91zc
    91zc is offline
    Inactive Member 91zc's Avatar
    Join Date
    October 3rd, 2001
    Posts
    576
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    I am doing the b16 swap myself in the next three weeks so I will tell you then. I am no expert mechanic but I don't think it will be that difficult. I think if I take my time and use a good shop manual it should be straightforward. Plus I will save a pretty good amount of money in labor. smile

    ------------------
    1991 Civic 4dr
    ZC-blown head gasket
    Zdyne Ecu
    Si tranny
    Thermal R&D exhaust
    Iceman
    Chikara header
    Weapon R Circuit Pro
    KYB AGX's
    Powerslot Rotors
    AEM/Nissin Pads
    Going B16--very soon
« I beat the new monte carlo ss... | where to buy a B16A »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules